I have 2 bass guitars sitting around. One is an 80's Fender PJ bass that I bought 8 or so years ago. I tried to refinish the body and... well.. it was kind of a disaster. I did learn a lot though, so that's something. Number one... if there's a wood veneer on the body... don't remove it. Number two... stripping paint sucks.
It may look okay from a distance, but I promise you, I did a terrible job, AND I wired it improperly. I had purchased a pearloid pickguard to go on there, but the body was some weird size, so I cut my own pickguard.
The second is a fender squier PJ bass that someone gave to my girlfriend because it's a POS with a terribly bent neck. I tried to adjust the truss rod a few years ago and just ended up stripping out the adjustment bolt. Oops. The pictures here don't do the neck curvature justice... imagine the curve you see WITH strings pulling it farther. The action close to the body was about 1/2''. I was t
As you can see, it's as straight as Elton John |
Last weekend I got all fired up about fixing it, so I decided that I was going to replace the truss rod. In order to do that, I need to remove the fingerboard. I was a bit worried about damaging it... but the neck is shot anyway, so I decided to go for it. I learned that the best way to do it is to use a clothes iron on the steam setting to loosen the glue, and then for VERY slowly to avoid damaging the fragile fingerboard.
I sat there for about 2 hours, playing Deus Ex, refilling the iron as needed, making sure things didn't burn, and prying the fingerboard a bit more every 10 minutes or so. At first, I was making good progress... the finger board was coming up clean and straight... but once I got to the 7th fret it cracked. By that point I was able to look under the fingerboard where the truss rod *should* be... but it was completely sealed up! No way to remove the truss rod. I kept removing the fingerboard for a while for the practice, but eventually gave up and just pulled it off.
Truss rod? Where are you?!? |
Hooray! Bass Geeetar! Well... almost. After I tried to set the intonation, it was a total wreck. It's WAY flat. It's so flat that I can't adjust the saddles far enough to get it in tune. After the fact, I realized that the new neck is a 22 fret, and the old neck was a 20 fret. The old neck is about an inch shorter. I either need to move the bridge, or mod it in some creative way to make it work correctly...
No comments:
Post a Comment